Wavecom W-SPECTRA (Automatic Monitoring System) V1.1.0 Instrukcja Użytkownika Pobierz pdf (Strona 60)



Parameters and Options WAVECOM Monitoring System W-SPECTRA, W-SPEED Manual V1.1.0

Frequency Offset

By adjusting the middle frequency tuning cursor in the narrowband spectrum display the user can place a

signal for correct decoding. The relative distance of the middle cursor to the spectrum middle appears in

the “Freq Offset” of the W-SPECTRA GUI.

Moving the middle frequency tuning cursor in the narrowband spectrum

display will set the “Frequency Offset”.

The “Freq Offset” should be set, so that

 For HF and VHF/UHF-SUB modes, the signal appears at the right side of the middle frequency tun-

ing cursor.

 For VHF/UHF-DIR and SAT (satellite) mode, the middle frequency tuning cursor is placed at the

middle of a signal.

NB FFT Gain

The user may adjust the “NB FFT Gain” to amplify or weaken the signal level: when no signal is appearing

in the narrowband spectrum display, the user may increase the gain to view and decode the signal.

Adjust the “NB FFT Gain” to reach a good FFT display and decoding quality.

Note: To reach a good decoding quality the user should usually use a small gain value. The gain should be

set to a value, so that the signal appears just a little bit in the narrowband spectrum display.

Custom Alphabets

The user can define his own “Custom Alphabets” under the menu “Configuration” -> “Custom Alphabets”.

Only 5-bit alphabets are accommodated, and the number of custom alphabets is limited to 16.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 291 292

Brak uwag

Wavecom W-SPECTRA (Automatic Monitoring System) V1.1.0 Instrukcja Użytkownika Strona 60